Reply
N/A
Posts: 1
Registered: August

HP Latex 310 - Stops printing mid-print curing error

Can anyone shed any light on the following error message ?

 

The print will be going along fine, and all of a sudden stop. The error message pops up, and asks you to reset the printer.

 

This has happened a few times up to this point, and is worrying me. 

 

The fans do seem to amp right up to full speed just before the print stops20170811_103609.jpg20170811_103614.jpg20170811_103623.jpg20170811_103631.jpg.

 

Any advice appreciated

Administrator
Posts: 343
Registered: ‎01-09-2017

Re: HP Latex 310 - Stops printing mid-print curing error

Hello @Artifax

Have you update to the New Firmware for HP Latex 310/330/360/370 Printers?

Please let me know if this has solved the issue.

 

 

N/A
Posts: 2
Registered: ‎12-07-2016

Re: HP Latex 310 - Stops printing mid-print curing error

I had a similar error once. I turned off the printer, unplugged the printer, opened the back panel and checked all the connections to the various boards and the problem went away. Not sure if HP techs would be happy with that, but it was a quick solution.

But, if the sensor has to be replaced, you'll need to get a tech out to your site.

Highlighted
N/A
Posts: 11
Registered: ‎07-25-2016

Re: HP Latex 310 - Stops printing mid-print curing error

Hi LatexLiebhaber

 

Please note that any modifications performed by non authorized personel to the printer can cause issues with the warranties as well as possible safety hazards such as electrocution and fire risks.

Regarding the SE a firmware upgrade is advised, if the issue persists then contacting your dealer to perform the appropiate checks would be the next step.

Warm regards!

Remember

To make recommendations or participate please click Register or Sign In and post a message.